Go Back   GsmSociety > GSM & CDMA Phones / Tablets Software Area > Chinese Models & Cloned Phones

Add For Rent
Thread Tools Search this Thread Display Modes
Old 12-10-2016, 03:30 PM   #1
Super Moderator
GsmBoss's Avatar
Join Date: Dec 2015
Posts: 176
Thanks: 21
Thanked 15 Times in 6 Posts
Default Micromax Bolt D321 Dead After Flash Tested 1000% Soloution

I Saw In MicroMax Section EveryDay 1-2 Post About The D321 Model After Flash Dead Compleatly And No Activity In Device Manager..

So I Post A Soloution Not Only D321 Its For All MicroMax Phones..

1. Connect a jumper wire from volume up key to ground as shown in below picture.
2. Press & hold the power key and do the flashing.
3. After flashing, remove jumper wire as added.
4. Power on the handset. It will work properly.
6. Congrats Its Done!! Phone Is Alive...

The Point IMAGE Below In This Picture :

Note: Don’t forget to remove jumper wire from volume up key after flashing.

GsmBoss is offline   Reply With Quote


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Micromax A51 Dead Recovery Done . JONONItelecom™ Micromax 0 15-06-2016 09:16 PM
Micromax a67 Flashing all type soloution here JONONItelecom™ Micromax 0 06-06-2016 01:21 PM
SOLUTION ||Micromax AQ4501 Canvas V1 Dead After Flash JONONItelecom™ Micromax 0 06-06-2016 01:18 PM
micromax aq4501 1000% sucessfully flashed OG JONONItelecom™ Chinese Models & Cloned Phones 0 04-06-2016 12:30 PM
Winmax W800 All Version official firmware 1000% tested JONONItelecom™ Chinese Models & Cloned Phones 0 27-05-2016 02:21 PM

All times are GMT +7. The time now is 01:17 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions, Inc.