SAMSUNG GALAXY S7 EDGE SM-G935S
Reset FRP Done Z3X 30 sec
SAMSUNG G935S FRP Done Z3X
To reset Google account activation or Samsung reactivation lock:
1. ADB must be activated in any way (you can flash sBoot from combination firmware,
make sure, that you are not upgrade sBoot).
2. Connect the phone to PC with USB cable, install drivers if needed.
3. Select device in ADB settings.
4. Press 'Reset FRP/React/EE' to deactivate Google/Samsung/EE account activation lock.
(Sometimes needs to perform 'wipe data/factory reset' once more, to complete this locks removal.)
To reset Google account activation lock with UART cable:
1. Phone must be powered off
2. Connect the phone to UART cable.
3. Select correct COM port in port settings.
4. Press 'Reset FRP UFS' and follow the instructions in program.
Operation: Reset FRP UFS
Selected model: SM-G935S
Selected port: COM130 Z3X BOX Serial Port
Software version: 30.8
Hold 'Vol down' and press 'POWER ON' for 2-3 seconds
Checking phone at COM130 OK
Phone detected, do not release 'Vol down'
Reading data from phone... OK
Release 'Vol down' now
Comparing selected model... match (G935S)
Setup connection... OK
Reseting FRP... OK
Rebooting phone... OK
Reset FRP done
Done with Samsung Tool PRO v.30.8
Reset FRP Done Z3X 30 sec
SAMSUNG G935S FRP Done Z3X
To reset Google account activation or Samsung reactivation lock:
1. ADB must be activated in any way (you can flash sBoot from combination firmware,
make sure, that you are not upgrade sBoot).
2. Connect the phone to PC with USB cable, install drivers if needed.
3. Select device in ADB settings.
4. Press 'Reset FRP/React/EE' to deactivate Google/Samsung/EE account activation lock.
(Sometimes needs to perform 'wipe data/factory reset' once more, to complete this locks removal.)
To reset Google account activation lock with UART cable:
1. Phone must be powered off
2. Connect the phone to UART cable.
3. Select correct COM port in port settings.
4. Press 'Reset FRP UFS' and follow the instructions in program.
Operation: Reset FRP UFS
Selected model: SM-G935S
Selected port: COM130 Z3X BOX Serial Port
Software version: 30.8
Hold 'Vol down' and press 'POWER ON' for 2-3 seconds
Checking phone at COM130 OK
Phone detected, do not release 'Vol down'
Reading data from phone... OK
Release 'Vol down' now
Comparing selected model... match (G935S)
Setup connection... OK
Reseting FRP... OK
Rebooting phone... OK
Reset FRP done
Done with Samsung Tool PRO v.30.8