I Saw In MicroMax Section EveryDay 1-2 Post About The D321 Model After Flash Dead Compleatly And No Activity In Device Manager..
So I Post A Soloution Not Only D321 Its For All MicroMax Phones..
1. Connect a jumper wire from volume up key to ground as shown in below picture.
2. Press & hold the power key and do the flashing.
3. After flashing, remove jumper wire as added.
4. Power on the handset. It will work properly.
6. Congrats Its Done!! Phone Is Alive...
The Point IMAGE Below In This Picture :
Note: Don?t forget to remove jumper wire from volume up key after flashing.
So I Post A Soloution Not Only D321 Its For All MicroMax Phones..
1. Connect a jumper wire from volume up key to ground as shown in below picture.
2. Press & hold the power key and do the flashing.
3. After flashing, remove jumper wire as added.
4. Power on the handset. It will work properly.
6. Congrats Its Done!! Phone Is Alive...
The Point IMAGE Below In This Picture :
Note: Don?t forget to remove jumper wire from volume up key after flashing.